AEM V3 Water / Methanol Injection Kit Multi Controller + 2 Gallon Boost Juice. AEM V3 Water/Methanol Injection Kit # 30-3350 x1.Snow Performance - Methanol Injection Boost Juice # 40008 x2. Water/methanol injection for gas engines is a proven means for effectively reducing engine inlet air temperatures and suppressing harmful detonation on high compression naturally aspirated (NA) race engines. This allows racers to reliably increase boost and advance ignition timingwithout using high-octane racing fuelfor improved power gains. AEMs Water/Methanol Injection Systems utilize the most robust hardware combined with more advanced features than any other comparably priced water/methanol system. AEM's Multi Input controller design enables users to install Water/Methanol Injection on high compression naturally aspirated vehicles (NA) via the MAF/IDC settings.
The Multi-Input controller works with an external 0-5v voltage-based external MAP sensor, a frequency based input for Injector Duty Cycle (IDC), frequency-based mass airflow (MAF), or a 0-5v voltage-based MAF. The Multi-Input Controller is available with a 1.15-gallon tank. Boost Dependent and Multi-Input (0-5v/frequency) progressive controller designs feature large adjustment knobs, integrated plug for harness connection, integrated fuse, covered status light and test button for enhanced splash resistance and mounting tabs.
Wiring harness is terminated with a positive-lock connector on one end with color-coded wires to ease installation, integrated pump ground circuit and additional wire for optional on/off fluid solenoid. Boost Safe failsafe output included (for complete failsafe under all conditions, see our Water/Methanol Failsafe Device). Heavy-duty high-pressure injection pump features integral fittings, a Santoprene diaphragm and EPDM seals to resist corrosion. Our pump maximizes line pressure for optimum atomization and its quiet, smooth operation is almost undetectable. Precision-machined billet-aluminum injector with integral check valve.
Three interchangeable injector nozzles to cover a wide variety of HP levels (250cc/min, 500 cc/min & 1,000cc/min). 1.15-gallon tank with anti-starvation reservoir, integral conductive low-fluid sensor and positive lock connector (tank-less systems available). 20 feet of injection tubing included.LED dash light for system status and low fluid warning. 2- Part Number: Snow Performance. Boost Juice is Snow Performances proprietary mix of 49% methanol and 51% purified water. It is made in a controlled environment with special care to make sure the ratios are accurate to result in a high performance water-methanol fluid formulated for use in the Boost Cooler injection system. CP Cometic ACL Ferrea and ARP Kits.
Your address must be confirmed. Buyers who pay with unconfirmed addresses will not be accepted. We always look to satisfy our customers in whatever needs they may have.
The item "AEM V3 Water / Methanol Injection Kit Multi Controller + 2 Gallon Boost Juice" is in sale since Monday, November 9, 2020. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts & Accessories\Air & Fuel Delivery\Other Air & Fuel Delivery". The seller is "boostprojects" and is located in San Diego, California. This item can be shipped to United States.