Wavtech bassRESTOR 2ch LOC/Line Driver with Bass Restoration

  

Adjustable effect (min-max), width (narrow-wide), frequency (30-80 Hz). Variable subsonic filter (15-50 Hz, 24 dB/octave). Active 2-channel line driver/output converter. Designed to work with aftermarket and factory systems. Wired remote level and bass effect control and 16-foot cable included.

Provides up to 10Vrms output. Selectable speaker-level input sensitivity (20V or 40V) via internal jumper. Auto turn-on via DC offset or audio detect. Gain control and clip light. Speaker-level inputs feature load resistance to prevent factory stereo shut-down.

Optional plug-in load resistors available for vehicles like some newer Chrysler vehicles that need less resistance for the factory stereo's load-sensing to work. Wiring, fuse, and hardware not included with device. 18-gauge power and ground leads and a 1-amp fuse recommended. Dimensions (not including terminals and jacks): 5-1/4"W x 1-1/8"H x 3-1/2D.

What's in the box. 2-Channel line output converter/line driver/Bass Processor. 5 meter RJ-45 remote cable. Written by Crutchfield's Buck Pomerantz. You love bass in your music, but sometimes your music doesn't have that much bass in it - like a lot of Classic Rock and Latino recordings.

Wāvtech's bassRESTOR lets you add what's missing, creating the low bass notes you want that weren't emphasized on the recording. Provides a strong clean signal. Your aftermarket amplifier needs strong and clean input signals, whether getting them from a receiver's RCA outputs or a factory amp's speaker outputs.

The bassRESTOR can produce up to 10 volts of output in either scenario, acting as a line driver using its RCA inputs or as a line output converter using the speaker-level inputs.